Table of Contents
Advertisement
Figure 61
1. Transmission pulley
2. Transmission
3. Socket (belt-tension
bracket)
3.
Slip the transmission-drive belt of the engine,
tensioner, and transmission pulleys
4.
Route the new transmission-drive belt around
the engine, tensioner, and transmission pulleys
as shown in
Figure 61
5.
Release the belt-tension bracket and allow the
spring to tension the belt
Note:
Make sure that the belt-tension bracket
and pulley can move freely.
g025999
4. Engine pulley
5. Tensioner pulley
(Figure
61).
(Figure
61).
Controls System
Maintenance
Adjusting the
Traction-Control Linkage
1.
Park the machine on a level surface.
2.
Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3.
Push the control lever all the way forward to the
front reference bar.
4.
If the control lever contact the reference bar
or do not contact the reference bar perform
the following:
A.
Release the control lever and allow it to
return to the neutral position.
B.
Remove the spring-clevis pin from the fork
fitting of the traction-control linkage
62).
1. Spring-clevis pin
2. Locknut
C.
Adjust the fork fitting to set the initial gap
as follows:
•
If the control lever contacts the
reference bar, rotate the fork fitting
(Figure
from the top of the machine).
•
If the control lever does not contacts
the reference bar, rotate the fork fitting
(Figure
D.
Install the spring clevis pin
move the control lever forward.
E.
Repeat this steps
is a gap approximately 1.6 mm (1/16 inch)
52
Figure 62
3. Turnbuckle
62) counterclockwise (as viewed
62) counterclockwise.
(Figure
A
through
D
until there
(Figure
g020223
62) and
Advertisement
Table of Contents
