Rear Panel Leds - Cisco 1700 Hardware Installation Manual

Overview
7
9
11
13

Rear Panel LEDs

The following figure shows the rear panel LEDs and describes their states.
Figure 10: Rear Panel LEDs and Their States
1
3
USB 3.0 Type A (USB 1)
You can connect a keyboard, and along with a
monitor on the VGA port, you can access the
console.
CIMC interface (labeled M)
Note CIMC is supported only for LOM
access. CIMC is not supported on
any other interfaces.
VGA video port (DB-15 connector)
1050-W AC power supply (PSU 2)
Unit identification:
• Off—The unit identification function is not
in use.
• Blue, flashing—The unit identification
function is activated.
100-Mbps/1-Gbps/10-Gbps Ethernet link status
(speed on both LAN1 and LAN2):
• Off—No link is present.
• Green—Link is active.
• Green, flashing—Traffic is present on the
active link.
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
8 USB 3.0 Type A (USB 2)
You can connect a keyboard, and along with a
monitor on the VGA port, you can access the
console.
10 Serial console port (RJ-45 connector)
Disabled by default; use the VGA port and
keyboard USB port instead.
12 1050-W AC power supply (PSU 1)
14 —
100-Mbps/1-Gbps/10-Gbps Ethernet link (speed
2
on both LAN1 and LAN2):
• Off—Link speed is 100 Mbps.
• Amber—Link speed is 1 Gbps.
• Green—Link speed is 10 Gbps.
4 1-Gbps Ethernet dedicated management link:
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Gbps.
• Green—Link speed is 1 Gbps.
Rear Panel LEDs
13