Adjustments
(continued)
Blade Elevation
When the eIevation handwheel
is turned clockwise, until
it stops, the blade must not be more that 2-5/8 inches
above the table
If the b}ade extends more than 2-5/8
inches, the motor could interfere with the underside of the
table causing misalignment,
With the blade extending 2-5/8 inches above the table,
the stop collar and spacer must be against the elevation
screw pivot nut
If the blade extends more that 2-5/8
inches, loosen two screws in stop collar, and readjust it,
Step
Elevation
Spacer
!
I
"Elevation
Screw
Pivot Nut
1
f
Tilt Screw
Tilt Screw
Pivot Nut
Tilt and Elevation
Mechanism
The handwheels
should turn freely without binding, The
turning action can be adjusted by tighten{ng or loosening
the screws
in the bearing
retainer
Both handwheels
must be removed to reach the adjusting screws
NOTE: When adjusting the screws on the tilt bearing
retainer, ho_d the nut inside using a 3/8" wrench, The
screws for the elevation bearing retainer can be reached
with a small screwdriver through the curved slot on the
front of the saw
Tilt
Handwheel
Elevation
_'_
_-_
Handwheel
Adjust Thes_
!
,_'_-,,_J_
Two Screws
_
_OJ
F[_
Adjust
These
Two Screws
42