Table of Contents
Advertisement
Dadoing
instructions for operating the dado head are contained in
booklet furnished with the dado head
The arbor on the saw, is only long enough so that the
widest cut that can be made is 9/16" wide
It is not necessary
to install the outside loose collar
before screwing on the arbor nut, Make sure the arbor
nut is tight.
WARNING:
For your own safety, always
use dado 1
insert listed under recommended
accessories,
J
When
using the dado head,
it will be necessary
to
remove the blade guard and spreader
Use caution. Use
miter gauge,
fence,
featherboards
or push sticks as
required,
WARNING:
For your
own safety,
always replace
/
the blade,
table
insert,
guard and spreader
when
]
you are finished
dadoing.
Lc°e_lSae
J_
Arbor
jitjiL_lii -_
Arbor
Rabbeting
Definition: Cutting out a section of the corner of a piece of
material, across an end or along an edge
To make a rabbet requires cuts which do not go all the
way through the material
Therefore, the blade guard
must be removed_
I Remove blade guard
2, For rabbeting along an edge (long way of workpiece)
as shown add facing to rip fence approximately as high
as the workpiece is wide Adjust rip fence and blade to
required dimensions; then make first cut with board flat
on table as any rip (type) cut; make second cut with
workpiece
on edge
Follow all precautions,
safety
instructions, and operational instructions as for ripping,
or rip type operations,
including featherboards
and
push stick, etc,
3 For rabbeting
across an end, for workpiece
10-1/2"
and narrower, make the rabbet cut with the board flat
on the table Using the miter gauge fitted with a facing,
follow the same procedures and instructions for cross
cutting making successive cuts across the width of the
workpiece
to obtain the desired width of cut, Do not
use the rip fence for rabbeting across the end
I WARNING:
For your
own
safety,
install
blade
guard immediately
upon completion
of rabbeting
operation.
Some rabbet cuts can also be made in one pass of the
workpiece over the cutter using a dado head
Rabbet
Second Cut
This Side
Against
Fence
When Making
Second Cut
First Cut
Second Cut Etc.
,,i
J
i
i
First Cut
abbet
35
Hide quick links:
Advertisement
Table of Contents
