Table of Contents
Advertisement
Available languages
Available languages
Installing or removing offset-diamond-
wheel cover (Optional accessory)
2
► 1. Offset-diamond-wheel cover 2. Screws 3. Set band
When using an offset diamond wheel, install the off-
set-diamond-wheel cover.
To install the offset-diamond-wheel cover, insert the set band
through between the tool body and the tube, and then fit it onto
the tool. The notch of the set band position just below the joint.
Set the offset-diamond-wheel cover and secure it and
the set band by firmly tightening the screws.
To remove the offset-diamond-wheel cover, follow the
installation procedure in reverse.
Installing or removing offset diamond wheel
125 mm, M14 threaded (Optional accessory)
To install the offset diamond wheel, press the shaft lock,
and screw the offset diamond wheel on the tool.
1
► 1. Lock nut wrench 2. Shaft lock
1
3
2
8 ENGLISH
To remove the offset diamond wheel, press the shaft
lock, place the lock nut wrench on the holes of the
wheel and turn it counterclockwise.
In case the holes don't match with
the lock nut wrench
Remove the front-edge cover by sliding it. Then press
the shaft lock and hold the two parallel flats of the offset
diamond wheel by a wrench and turn it. If you can't see
the parallel flats, press down the offset-diamond-wheel
cover with your fingers.
Hose connector assembly
► 1. Water cock 2. Hose connector 3. Connector
4. Hose
Use the hose connector assembly to connect to water
source. It consists of the following parts.
Part name
Hose Connecter
Connecter
Hose
Assemble the above parts hand tight as follows.
1.
Attach the hose connector to the outlet of water
cock.
2.
Tighten the connector firmly to the hose. Insert the
connector to the hose connector as far as it will
go.
3.
Tighten the hose connector to the end of the hose.
4.
Fit the hose connector to the port on the tool.
1
2
3
4
2
Description
1/2" pipe thread
1/2"mail pipe thread
5/8"in inner diameter x 25" in length
Advertisement
Table of Contents
