Makita PK5011C Instruction Manual page 7

1
3
► 1. Head cover 2. Screw 3. Side grip
If the tool comes with a head cover, remove one of the
screws which secure gear housing and head cover, and
then screw the side grip on the tool.
Installing or removing dust cover for
abrasive disc (Optional accessory)
3
4
► 1. 125mm dust cover 2. Dust cover band A 3. Dust
cover band B 4. Screws
When using an abrasive disc, use the 125 mm dust
cover together.
To install the dust cover, insert the dust cover band A
through between the tool body and the tube, and then fit
it onto the tool. The notch of the dust cover band posi-
tions just below the joint.
Set the dust cover so that the notch of the dust cover
fits to the protrusion of the bearing box.
Secure the dust cover band B by firmly tightening the
screws.
To remove the dust cover, follow the installation proce-
dure in reverse.
Installing or removing abrasive disc
(Optional accessory)
NOTE:
• Use sander accessories specified in this man-
ual. These must be purchased separately.
1
2
2
3
4
► 1. Lock nut 2. Abrasive disc 3. Rubber pad 4. 125
mm dust cover
1
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
2
2
► 1. Lock nut wrench 2. Shaft lock
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, and then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
7 ENGLISH
1