Selecting A Special Mode - Sharp MX-4100N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the general procedure is the same. The
procedure for erasing shadows at the edges of the image when sending a fax is explained below as an example.
The side to be scanned must be face up!
Scan Internet Fax Fax USB Mem. Scan
Address Book
Original Auto
Scan:
Direct TX Auto
Exposure
Sub Address
Resolution Standard
Special Modes
Address Review
(1)
File
Quick File
Auto Reception
Preview
Fax Memory:100%
Fax/Special Modes
Program Erase
(2)
Timer
2in1
Job Mixed Size
Build
Original
Original
File
Count
Fax/Special Modes
Erase
Edge Center Edge+Center
Erase Erase Erase
Side Erase
1
2
PC Scan
8½x11 Auto
Send:
OK
Dual Page
Scan
1
Card Shot 2
Slow Scan
Mode
Quick File
OK
(4)
Cancel OK
Edge
3/4
(0~1)
inch
(3)
3
Place the originals.
When using the document glass, place the original with the
side to be scanned face down.
Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
The erase settings will be configured to erase a width
of 3/4" around the edges of the original.
(3) Set the erasure width to 3/4" with the
keys.
The erase area is set to "Edge Erase" by default.
To select "Center Erase", "Edge+Center Erase", or
"Side Erase", touch the appropriate key.
(4) Touch the [OK] key.
Enter the fax number of the receiving fax
machine and press the [BLACK & WHITE
START] key.
Cancel scanning
75