Install The Header Bracket - Craftsman 139.53661SRT1 Owner's Manual

Installation Step 2 I
Install the Header Bracket
i
You can attach the header bracket either to the
wall above the garage door, or to the ceiling.
Follow the Instructions which will work best for
your particular requirements,
Fasten the Header Bracket to the Wall
• Center the bracket on the vertical guideline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointing toward the
ceiling).
• Mark either set of bracket holes (do not use the
holes designated for ceiling mount). Drill 3/16" pilot
holes and fasten the bracket securely to a structural
support with the hardware provided.
Wall
Mount_ Holes
"" "*Lag Screws f
Spring " The nail ho_ is for posilioning \ //
only. y_J must use lag scrk=e_t s 1o V
mouni the header b'acket.
opt_lal
Wall Mounting
Ho_es
le_
Door
Vertical
Center
Line
Hardware Shown Actual Size
_16"-9XI-_"
Fasten the Header Bracket to the Ceiling
• Extend the vertical guideline onto the ceiling as
shown.
• Center the bracket on the vertical mark, no more
than 6" from the wall. Make sure the arrow is
pointing toward the wall. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
• Mark holes designated for ceiling mount only• Drill
3/16" pilot holes and fasten bracket securely to a
structural support with the hardware provided.
Ceil!rigMountingHoles
"n_naJho_L_ forpo=_k_ng only.
You rnust use kRgscrews to motml_
the header btackel.
Door
Spdng
14