Battery Protection System; Connecting Usb Devices - Makita DCX200 Instruction Manual

Meaning of the indicator lamp
Indicator lamps
Lighted Off
(For LXT batteries only)
(For LXT batteries only)
NOTE: For LXT batteries only:
The first (far left) indicator lamp will blink when the
battery protection system works.
Battery BL1055B
While the battery BL1055B is unplugged, press the power but-
ton. The battery capacity indicator lights up for a few seconds.
Fig.12
► 1 . Power button 2. Battery capacity indicator
Meaning of the indicator lamp
Indicator lamps
Lighted Off
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
Less than
25%
Charge the
battery.
The battery
may have
malfunctioned.
2 1
Remaining
capacity
Blinking
50% to 100%
25% to 50%
10% to 25%
Less than
10%
Battery
abnormality

Battery protection system

If the remaining battery capacity is too low, the device
will not operate. When you turn the device on, the
power is supplied to the heating parts again, but stops
soon. In this situation, remove and recharge the battery
cartridge.

Connecting USB devices

CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction.
NOTICE:
Before connecting a USB device,
always back up the data on the USB device. Not
doing so may cause a loss of your data.
NOTICE:
The battery holder and Battery
BL1055B may not supply power to some USB
devices.
NOTICE:
When not using or after charging,
remove the USB cable and close the cover.
NOTE: The actual output current varies depending on
the USB device to be connected.
NOTE: Battery power is consumed while the power
button is turned on. Always turn off the switch when
not in use.
NOTE: When charging multiple USB devices in suc-
cession, wait about 10 seconds after charging of the
previous device has completed before beginning to
charge the next device.
The battery holder (with the battery) and Battery
BL1055B can work as an external power supply for
USB devices.
1. Open the cover and connect a USB cable (not
included) to the USB port. Then connect the other end
of the cable to the device.
2. Start charging:
— When using battery holder (with the battery), press
and hold the power button until the power level
indicator lights up. The battery supplies DC 5 V,
2.4 A.
Battery holder (with battery)
Fig.13
► 1 . Power button 2. USB port
10 ENGLISH
2
1