Advertisement
Initial Configuration Using Console Port
accessed through the console port or using SSH, HTTPS, or REST API accessed through the management
port (this procedure is also referred to as low-touch provisioning).
Initial Configuration Using Console Port
The first time that you access the Firepower 4100/9300 chassis using the FXOS CLI, you will encounter a
setup wizard that you can use to configure the system.
Note
You must specify only one IPv4 address, gateway, and subnet mask, or only one IPv6 address, gateway, and
network prefix for the single management port on the Firepower 4100/9300 chassis. You can configure either
an IPv4 or an IPv6 address for the management port IP address.
Before you begin
1. Verify the following physical connections on the Firepower 4100/9300 chassis:
For more information, refer to the hardware installation guide.
2. Verify that the console port parameters on the computer terminal (or console server) attached to the console
port are as follows:
3. Gather the following information for use with the setup script:
Getting Started
2
To repeat the initial setup, you need to erase any existing configuration using the following commands:
Firepower-chassis# connect local-mgmt
firepower-chassis(local-mgmt)# erase configuration
• The console port is physically connected to a computer terminal or console server.
• The 1 Gbps Ethernet management port is connected to an external hub, switch, or router.
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
• New admin password
• Management IP address and subnet mask
• Gateway IP address
• Subnets from which you want to allow HTTPS and SSH access
• Hostname and domain name
• DNS server IP address
Getting Started
Advertisement
