Table of Contents
Advertisement
3
Operation of the appliance
Make the electrical connections of
the appliance. Your appliance uses
2X2 W spot LED lamp. For replacing
the lamps, push downwards on the
holder from its behind, turn it coun-
ter-clockwise, and take it out down-
wards. Apply the above operation in
reverse to install new lamps.
Bulb
Bulb Power
2X2 W
Holder / Socket
E14
Bulb Voltage
220-240V~ 50-60Hz
Size
25 x90 mm
• Before replacing the light
bulbs, disconnect the power
supply of the hood.
A
• Do not touch the light bulbs
when they are hot.
• Be careful not to touch the
replaced light bulb directly
with hands.
C
You may procure lamps from
Authorised Service Agents.
3.5 Operation with flue
connection
Vapour is extracted thro-
•
ugh the flue duct, which
is fastened to the con-
nection head on the
hood.
• The diameter of the flue duct must be
the same as the connection ring. In ho-
rizontal settings, the pipe has to have
Cooker Hood / User Manual
a slight upward slope (around 10º) so
that the air can exit the room easily.
3.6 Operation without flue
connection
Air is filtered through the
•
carbon filter and recircu-
lated in the room. Carbon
filter is used when it is im-
possible to use a flue in
the house.
• In flueless use, remove the flaps inside
the flue adapter.
• Remove the oil filter. To install the car-
bon filter, fit the filter to the tabs by
centring it on the plastic piece on both
sides of the fan body. Tighten it by tur-
ning right or left.
Replace aluminium oil filter.
•
11 / EN
Advertisement
Table of Contents
