Removing The Collected Water - Zanussi ZD2023 User Manual

OPERATING THE UNIT

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
When the unit is off,if the bucket is full, the unit
will beep 20 times and the Full indicator light will
flash
When the unit is on,if the bucket is full, the
compressor turns off and the fan turns off after
3 minutes for drying the water of the condenser
then the unit will beep
indicator light will flash,
Slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull out
straight so water does not spill. Do not put
the tank on the floor because the bottom of
the bucket is uneven. Otherwise the bucket
will fall and cause the water to spill.
Throw away the water and replace the bucket.
The bucket must be in place and securely
seated for the dehumidifier to operate.
The machine will re-start when the bucket is
restored in its correct position.
NOTES:
When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product. Be sure to push the
bucket gently all the way into the unit.
Banging the bucket against anything or
failing to push it in securely may cause the
unit not to operate.
When you remove the bucket,if there is some
water in the unit you must dry it .
times and the Full
20
,
8 8
Water bucket
Fig.5
Water bucket
Drain hose outlet
Drain hose
Fig.6