Panasonic KX-TVS80 Installation Manual page 89

Voice processing system
Hide thumbs Also See for KX-TVS80:
Table of Contents

Advertisement

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Screen output:
5.
To set the trunk (CO line) features, follow the instructions in "Settings for the trunk (CO
line) features" (3.3.4 KX-TD500 Programming for Inband Integration with KX-TVS80 in
3.3 CONNECTING THE VPS WITH PANASONIC KX-T SERIES PBXs).
6.
Connect the jack assigned in Step 4 to the VPS.
7.
Connect your laptop computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
8.
Disconnect the power from the VPS and set the DIP Switch to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP Switch to position 5 will default the Voice Processing System, resulting in a
loss of all user programming and voice messages (except User 1 and User 2 prompts).
9.
Plug in and power up the VPS and wait approximately 2.5 min while the system initializes.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
Installation Manual
All manuals and user guides at all-guides.com
89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tvs50

Table of Contents