Panasonic KX-TVS80 Installation Manual page 297

Voice processing system
Hide thumbs Also See for KX-TVS80:
Table of Contents

Advertisement

To program the following 10 Parameters in the next table, use the Special Commands and Dial
Codes listed below. You can set up to 12 digits for each parameter.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Extension dialing
A: Answer
1-9, 0, , #: Dial Codes
Parameter
Operator
Transfer
Sequence
Extension
Transfer
Sequence
Alternate
Extension
Transfer
Sequence
Reconnect
Sequence on
Busy
Reconnect
Sequence on
No Answer
Reconnect
Sequence on
Refuse Call
Light-On
Sequence for
Message
Waiting Lamp
Light-Off
Sequence for
Message
Waiting Lamp
Installation Manual
All manuals and user guides at all-guides.com
Value Range
(Default)
The VPS performs this sequence when transferring calls
(FX)
to the operator's extension.
The VPS performs this sequence when transferring calls
(FX)
to any extension except the operator's.
The VPS performs this sequence when transferring calls
to extensions in the Alternate Extension Group.
(FX)
If an extension is busy, this sequence allows the VPS to
(F)
reconnect to the caller.
If the extension does not answer, this sequence allows the
(F)
VPS to reconnect with the caller.
The VPS performs this sequence to retrieve a call placed
(F)
on hold after the extension (in the Call Screening mode)
has refused to accept it.
This is the dialing sequence that the VPS must perform to
enable the Message Waiting Lamp at an extension.
(None)
This is the dialing sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.
(None)
SYSTEM ADMINISTRATOR'S GUIDE
Table 75
Description/Function
297

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tvs50

Table of Contents