Advertisement
7. Install the new nut (M16) onto the bolt and torque it
to 15 N∙m (11 ft-lb).
Note: Do not overtighten it as this will make the roll
bar difficult to fold.
8. Remove the roll bar pivot bolt on the right side of the
mower.
9. Align the indicated hole in the right rear light bracket
with the hole in the roll bar and insert the new bolt
(M16 x 110 mm), using the existing washers
4
or
Figure
5).
Figure 4
Machine with serial numbers 316999999 and lower
1. Nut (M16)
2. Existing washers
3. Roll bar
(Figure
4. Right rear light bracket
5. Orange indicator side up
6. Bolt (M16 x 110 mm)
Machine with serial numbers 400000000 to 999999999
1. Nut (M16)
2. Existing washer
3. Roll bar
10. Install the new nut (M16) onto the bolt and torque it
to 15 N∙m (11 ft-lb).
g197781
Note: Do not overtighten the nut, as this makes the
roll bar difficult to fold.
Note: If there is already a beacon kit fitted to the right
or left side, use the existing bolt and the new nyloc nuts
(M16) provided with this kit.
11. Feed all electrical cables down the front of the roll bar
frame and onto the electrical mount panel.
12. Connect the cables to the main wiring harness of the
machine which is located on the electrical bulkhead
(Figure
6), as follows:
A. Connect the 4-pin, left, rear, light-assembly, wiring
connector to the corresponding 4-pin electrical
connector on the left side of the main wiring
harness.
B. Connect the 4-pin, right, rear, light-assembly,
wiring connector to the corresponding 4-pin
electrical connector on the right side of the main
wiring harness.
Note: The 2-pin electrical connectors on the left
and right rear-light assembly is required for the
number-plate light. Only 1 of the 2-pin electrical
connectors is used.
4
Figure 5
4. Bolt (M16 x 110 mm)
5. Right rear light bracket
6. Orange indicator side up
g196537
Advertisement
