Advertisement
8. On the control panel, remove the round plug (horn
button) and the rectangular plug (indicator switch)
shown in
Figure
19.
1
2
Figure 19
1. Round plug—horn button
9.
Install the horn decal; line it up with the edges of the
round and rectangular holes
1
2
Figure 20
1. Horn button
2. Horn decal
10. Install the horn button and the direction indicator
switch onto the control panel
direction indicator switch with the green/red wires
to the left and the green/white wires to the right, as
shown in
Figure
21.
G018336
2. Rectangular
plug—indicator switch
(Figure
20).
3
G018335
3. Direction indicator switch
(Figure
20). Install the
G018338
g018336
1. Green/Red
11. Connect the direction indicator switch to the connector
lead instrument panel.
Note: The indicator connector is black and on the
longer lead.
12. Connect the pink wire and the black/purple wire to
the horn button.
Note: The pink wire and the black/purple wire are
located in the control panel.
13. Working under the operator platform, connect the
connector lead instrument panel to the multi-pin
connector on the machine's main electrical-wiring
harness.
Note: The multi-pin connector is located in the
chassis rail to the right of the transmission pump.
14. Attach cable ties to all cables for the front lights, rear
lights, and the pressure switch.
g018335
Important: Ensure that the cable ties properly
secure the cables. The ties will prevent the cables
from becoming trapped or chafed.
15. Connect the negative battery cable.
16. Test the switches on the control panel to ensure that
they are operating correctly.
17. Refit the control panel to ensure that no connectors
have become detached and that no cables are nipped.
18. Lower and latch the engine cover and operator's
platform.
10
1
2
Figure 21
2. Green/White
g018338
Advertisement
