Oven - Daily Use - AEG 17166GM-MN User Manual

12 www.aeg.com
cleaning, wipe the hob dry with a soft
cloth.
7.4 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal

8. OVEN - DAILY USE

WARNING!
Refer to Safety chapters.
8.1 Cooling fan
When the appliance operates, the
cooling fan activates automatically to
keep the surfaces of the appliance cool.
If you deactivate the appliance, the
cooling fan can continue to operate until
the appliance cools down.
If there is a defect in the
cooling fan, contact the
Authorised Service Centre.
8.2 Igniting the oven and grill
burners
CAUTION!
When the oven is active, the
lid has to be opened to
avoid over-heating.
Keep the oven door open
when you ignite the burner.
Oven safety device:
The oven burners have a
thermocouple. It stops the
gas flow, if the flame goes
out.
You cannot operate the top
oven burner, when the grill is
active.
1. Open the oven door.
2. Push the knob for the top oven and
turn it counterclockwise to
ignite the top oven burner.
• Push the knob for the top oven
and turn it clockwise to
ignite the grill burner.
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
• Push the knob for the main oven
and turn it counterclockwise to
to ignite the main oven burner.
3. Keep the knob pushed for equal or
less than 15 seconds to let the
thermocouple warm up. If not, the
gas flow is interrupted.
4. After ignition release the knob, close
the oven door and turn the knob to
set the necessary heat setting.
WARNING!
Do not push the knob for
more than 15 seconds. If the
oven burner does not light
after 15 seconds, release the
knob, turn it back to off
position and try to light the
oven burner again after
minimum 1 minute.
CAUTION!
In the absence of electricity
you can ignite the oven
burner without an electrical
device. In this case open the
oven door, put the flame
near the hole in the bottom
of the oven cavity, turn the
knob to the spark position
and push it down. Keep the
knob for the oven functions
pushed for equal or less than
15 seconds to let the
thermocouple warm up.
If the oven burner
accidentally goes out, turn
the knob for the oven
to
functions to the off position
and try to light the burner
again after minimum 1
minute.
to
Check if the burner holes are
not blocked.