Preparing The Remote Control Unit; Setting The Usb Flash Drive Cover - Sharp PN-T321 Setup Manual

Preparing the Remote Control Unit

Batteries and an insulation sheet are preinstalled in the remote control at the factory. Before using the remote control, be sure to
remove the insulation sheet.
1. Insert the USB flash drive into the USB port.
2. Attach the USB flash drive cover and secure with the provided screw.
Insert the claw (1) into the monitor, and while pressing in the direction of (2), insert the claw (3) into the monitor.
TIPS
• If the USB flash drive will be attached, use a USB flash drive with dimensions no greater than 3-1/8 inch (80 mm) (L) × 15/16
inch (25 mm) (W) × 7/16 inch (12 mm) (H).
• To remove the USB flash drive cover, reverse the procedure. Using excessive force may break the claws. Exercise caution.
Caution
• Do not touch any screws other than the black screw.

Setting the USB flash drive cover

Screw
(black)
USB flash drive cover
Insulation sheet
Pull out
USB port
(3)
(3)
(1)
(2)