Installing/Removing The Base - Sharp LL-173C Operation Manual

Installing/removing the base

CAUTION!
- Be careful not to touch the LCD panel when you
install/remove the base. The LCD panel used in
this monitor is made of glass. Pressure from
hands on the LCD panel could cause damage.
Installing the base
1. Place the base on a flat surface, such as a
desktop, and insert the stand carefully.
Insert the stand until it clicks.
CAUTION!
- Be careful not to allow your fingers to be
pinched.
- Check that the base is firmly installed before
use. If the installation is not performed
correctly, the monitor may fall down or the
base may drop.
Removing the base
1. Spread out a soft cloth on a flat surface. Being
careful not to damage the monitor, gently lay the
monitor on it display-side down.
2. Pinch the four levers inward at the back bottom
of the base while pulling the base toward you.
Stand
Base
10