Honeywell ADEMCO 4204 Installation Instructions page 2

Relay module

Hide thumbs

page of 2

/ 2
Bookmarks

SWITCH

OFF

NUMBER

DIP SWITCH (WHITE AREAS DENOTE SWITCH HANDLES)

POSITION 7: NO FUNCTION

POSITIONS 2-6:

POSITION 1: ENABLES/DISABLES COVER TAMPER. ON = TAMPER DISABLED,

4204

DIP SWITCH

FOR SETTING DEVICE ADDRESS

AND ENABLING/DISABLING TAMPER

COVER TAMPER (REED) SWITCH

Must be connected to a

power-limited source.

Supervised

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED FOR

DETAILS REGARDING THE LIMITATIONS OFTHE ENTIRE ALARM SYSTEM.

FEDERAL COMMUNICATIONS COMMISSION STATEMENTS

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes

or modifications could void the user's authority to operate the equipment.

CLASS B DIGITAL DEVICE STATEMENT

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions,

may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance

with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

If using an indoor antenna, have a quality outdoor antenna installed.

•

Reorient the receiving antenna until interference is reduced or eliminated.

•

Move the radio or television receiver away from the receiver/control.

•

Move the antenna leads away from any wire runs to the receiver/control.

•

Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

•

Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA CLASS B STATEMENT

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

FCC / IC STATEMENT

This device complies with Part 15 of the FCC Rules, and RSS210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1)

Cet appareil ne doit pas causer d'interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une réception

indésirable.

ÊN8909V4†Š

N8909V4 10/12 Rev. B

DIP SWITCH SETTINGS

9 10 11 12 13 14 15

ON — ON — ON — ON — ON — ON — ON — ON —

ON ON — — ON ON — — ON ON — — ON ON — —

ON ON ON ON — — — — ON ON ON ON — — — —

ON ON ON ON ON ON ON ON — — — — — — — —

ON ON ON ON ON ON ON ON

DETERMINE 4204'S ADDRESS: CONTROL'S INSTRUCTIONS SPECIFY ADDRESS

TO USE. "0" ADDRESS SETTING SHOWN (AS SHIPPED).