Table of Contents
Advertisement
Retrofitting the
large-surface
filter
AD water
connection for
30-1,000 kPa (UK:
100-1,000 kPa)
pressure -
pressure-
resistant
(optional)
AD water
connection for
8.5-60 kPa -
without pressure
(optional)
- The water inlet hoses are approximately 1.7 m long pressure hoses,
DN 10, with ¾ inch screw thread. The filters in the screw threads
must not be removed.
Do not shorten or otherwise damage the water inlet hoses
supplied with the machine.
See also the installation plan supplied.
IMPORTANT
UK, Australia and New Zealand
For the UK, Australia and New Zealand a non-return check valve is
required between the tap and optional filter.
If the water contains a high level of insoluble components, a large-
surface filter can be installed between the stopcock and the water
inlet hose.
The large-surface filter is available from the Miele Customer Service
Department.
This machine can be optionally supplied for a pressurised system
operating between 30-1,000 kPa (UK: 100-1,000 kPa). If the water
pressure is below 200 kPa the water intake duration will be
automatically increased.
The pressure tested hose for AD water, coded green, has a ¾ inch
threaded union for connection to the onsite stopcock for AD water.
If the machine is not going to be connected to demineralised
(DI) water, the DI water connection has to be deactivated by the
Miele Customer Service Department. The intake hose remains on
the back of the machine.
The machine has to be converted for connection to 8.5-60 kPa
pressure unless ordered as such at the factory. Installation of the
pump must only be carried out by Miele Service.
With a pressureless AD water connection, the drainage point must
be at least as high as the top of the machine. See installation
instructions.
Plumbing
149
Advertisement
Table of Contents
