Operation; Maintenance - Makita BO3710 Instruction Manual

Remove the pad for the conventional type of abrasive
paper from the tool with a screwdriver. Install the pad
for the hook-and-loop type of abrasive paper (optional
accessory) on the tool. Tighten the screws firmly to
secure the pad.
1
2
► 1 . Abrasive paper 2. Pad
Remove all dirt or foreign matter from the pad. Attach
the paper to the pad, aligning the holes in the paper with
those in the pad.
1
► 1 . O-ring
CAUTION:
• When removing the pad, O ring may come out
of the tool. When this occurs, return the O ring
to the original position and then install the pad.
Dust bag
1
► 1 . Dust spout 2. Dust bag
2
6 ENGLISH
Attach the dust bag onto the dust spout. The dust spout
is tapered. When attaching the dust bag, push it onto
the dust spout firmly as far as it will go to prevent it from
coming off during operation.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.

OPERATION

Sanding operation
CAUTION:
• Never run the tool without the abrasive paper.
You may seriously damage the pad.
• Never force the tool. Excessive pressure may
decrease the sanding efficiency, damage the
abrasive paper or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the work-
piece and apply slight pressure on the tool.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.