Table of Contents
Advertisement
4 Operation
Notice
You need to connect the projector to
an HDMI or USB-C device, so that the
projection screen can show images (see
Connect, page 7).
Place the projector
Place the projector on a flat surface in front of
the projection surface.
You can also install the projector in different
configurations (see Placement options, page
10).
Connect power supply
The projector can be operated by either
external power or built-in battery.
CAUTION!
Always use the
projector on and off.
Operation by external power
1
Fix an appropriate plug (EU, UK, US) onto
the round base of the power adapter by
aligning the pins and holes.
•
To detach the plug from the power
adapter, hold down the tab at the edge
of the round base, and simultaneously
turn and unlock the plug from the round
base of the power adapter.
US
EU
8
button to turn the
UK
2
Connect the power adapter to the
socket on the projector, and then to the
wall outlet.
a
Operation by built-in battery
The projector can be also operated on built-in
battery for portability.
Charge the projector
Charge the projector for 1.5 hours before first
use.
Charge the projector when the low battery icon
appears in the projection screen.
•
To charge the projector, connect the
projector to an external power supply as
described in the section of "Operation by
external power".
•
When charging, the LED on the projector
turns red. When fully charged, the red LED
turns off.
•
When powered on, the external power
will be used first to run the projector and
unused power will charge the battery.
•
For faster charging, charge while the
projector is powered off.
Notice
The capacity of the built-in battery
diminishes with time. If the projector
functions only with external power
supply, the built-in battery is defective.
Contact an authorised service centre to
replace the built-in battery.
b
Philips · PicoPix Micro 2
Advertisement
Table of Contents
