Using The Lithium Ion Battery Pack; Utilización De La Batería De Iones De Litio - Samsung SC-D263 Owner's Instruction Book

Samsung sc-d263: user guide
Hide thumbs Also See for SC-D263:
Table of Contents

Advertisement

ENGLISH
Preparation

Using the Lithium Ion Battery Pack

✤ Use SB-LSM80 or SB-LSM160 Battery Pack only.
✤ The Battery Pack may be charged a little at the time of purchase.
Charging the Lithium Ion Battery Pack
1. Turn the [Power] switch
to [Off].
2. Attach the Battery Pack
Once per second
to the Camcorder.
Twice per second
3. Connect the AC Power
Three times per second
Adapter to an AC Cord
Blinking stops and stays on
and connect the AC
On for a second and off for
Cord to a wall socket.
a second
4. Connect the DC cable to
the DC jack on the Camcorder.
The charging indicator will start to blink, showing that the Battery is
charging.
5. Press and hold the DISPLAY button while charging
and the charging status will be displayed on the LCD
for 7 seconds.
Indicated battery level is given as reference data
for the user, it is the approximate. It may differ from
Battery capacity and temperature.
6. When the Battery is fully charged, disconnect the
Battery Pack and the AC Power Adapter from the
Camcorder.
Even with the Power switched Off, the Battery Pack
will still discharge.
Charging/ Recording Times based on
Model and
Battery Type.
Battery
✤ If you close the
LCD Screen, it
SB-LSM80
switches off and the
Viewfinder switches
SB-LSM160
on automatically.
✤ The continuous
(Option)
recording times
given in the table to the right are approximations.
Actual recording time depends on usage.
✤ The continuous recording times in the operating instructions are
measured using a fully charged Battery Pack at 77 °F (25 °C).
✤ Even when the Power switched Off, the Battery Pack will still
discharge if it is left attached to the device.
16
16
Blinking time
Charging rate
Less than 50%
50% ~ 75%
75% ~ 90%
90% ~ 100%
Error - Reset the Battery
Pack and the DC Cable
B B a a t t t t e e r r y y c c h h a a r r g g e e d d
0%
Recording time
Time
Charging
time
LCD On
Viewfinder On
Approx.
Approx.
1hr 30min
1hr 20min
1hr 20min
Approx.
Approx.
2hr 40min
3hr
Preparación
Utilización de la batería de iones de litio
✤ Utilice únicamente la batería B-LSM80 o SB-LSM160.
✤ Es posible que la batería esté cargada sólo parcialmente al adquirir
la videocámara.
Carga de la batería
de iones de litio
1. Gire el interruptor
[Power] a [Off].
2. Conecte la batería a la
videocámara.
3. Conecte el adaptador
de CA a un cable de CA
y éste a una toma de corriente.
4. Conecte el cable de CC al terminal de CC de la videocámara.
El indicador de carga comenzará a parpadear, lo
cual indica que se está cargando la batería.
5. Presione la tecla DISPLAY mientras se produce la
carga y el estado de carga aparecerá en la pantalla
Battery Info
LCD durante 7 segundos.
50%
100%
6. Cuando la batería esté totalmente cargada,
desconecte la batería y el adaptador de CA de la
videocámara. Incluso con la videocámara apagada,
la batería se descargará.
Tiempos de
carga/grabación
basándose en el
modelo y el tipo
Approx.
de batería
✤ Si cierra la pantalla
Approx.
LCD, se apaga y el
3hr
visor se enciende
automáticamente.
✤ Los tiempos de grabación continua que se facilitan en la tabla son
aproximados.
El tiempo real de grabación depende del uso de la videocámara.
✤ Los tiempos de grabación continua en las instrucciones de
funcionamiento se miden utilizando una batería totalmente cargada a
25 °C (77 °F).
✤ Incluso con la unidad apagada, la batería se descargará si se deja
conectada al dispositivo.
Frecuencia de parpadeo
Una vez por segundo
Menos del 50%
Dos veces por segundo
50% ~ 75%
Tres veces por segundo
75% ~ 90%
Deja de parpadear y queda encendido
90% ~ 100%
Encendido durante un segundo
Error – Reinicialice la
y apagado durante un segundo
batería y el cable de CC
El nivel de la batería indicado que se facilita al
usuario son datos de referencia aproximados.
Puede que difiera de la capacidad y temperatura
de la batería.
Tiempo de grabación
Tiempo
Tiempo de
Batería
carga
LCD ENCENDIDA Visor encendido
Aprox. 1 h.
Aprox. 1 h.
SB-LSM80
20 min.
20 min.
SB-LSM160
Aprox. 2 h.
Aprox. 3 h.
(Opcional)
40 min.
ESPAÑOL
Velocidad de carga
Aprox. 1 h.
30 min.
Aprox. 3 h.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents