Cisco 3100 Series Hardware Installation Manual page 82

Secure the Power Cord on the Power Supply Module
Figure 54: Connect the Tie Wrap
Tie wrap
1
Step 3 Secure the clamp:
a) Plug in the power cord into the power supply module and wrap the clamp around the over mold portion of the power
cord.
b) Squeeze the clamp ends together so that the annular teeth engage with the mate on the clamp.
c) Make sure the clamp fits snugly into the over mold.
d) Adjust the clamp position on the tie wrap so that the clamp is tight against the front of the over mold and the power
cord cannot be removed by lightly pulling on it.
Figure 55: Clamp on Over Mold of Power Cord
1 Power cord
Cisco Secure Firewall 3100 Series Hardware Installation Guide
78
Installation, Maintenance, and Upgrade
Hexagonal hole
2
2 Power cord over mold
Clamp release tab