To adjust the carburetor settings on
settings, refer to
page 29 .
Basic factory settings
H = high speed jet
L = low speed jet
7.9 Handle and throttle trigger
7.9.1 To disassemble the handle
The first 2 steps in the instruction is only necessary
when you replace the throttle wire. To disassemble the
30 - Repair instructions
H
L
T
2.0
1.75
handle but not replace the throttle wire, start the
procedure at step 3.
1. Remove the 2 screws, the throttle wire cover and the
throttle wire from the carburetor.
2. If it is necessary to replace the electrical wires,
disconnect the short circuit cables.
1008 - 003 - 24.11.2020