8. Remove the vibration damping units.
9. Remove the straps and the fuel tank.
10. Remove the 4 screws (A) to remove the rear plate
(B).
11. If it is necessary to replace the foam plate (D),
remove the 4 clips (E) from the rear plate (B). Do not
remove the 4 nuts (C) from the rear plate (B), if it is
not necessary.
935 - 001 -
C
B
A
12. Assemble the harness frame in the opposite
sequence.
7.13 Handle and throttle trigger
7.13.1 To disassemble and assemble the handle
and the throttle trigger
1. Pull up the knob and remove the drive shaft tube.
2. Disconnect the cables and throttle wire.
E
3. If the product has a hand throttle handle, do these
steps:
D
Repair instructions- 49