Brake Pad Wear (Only Front Brake) - Honda CB Unicorn 160 Owner's Manual

Installation Notes:
To install the rear wheel, reverse the
removal procedure.
Make sure that the slot on the swingarm is
located in the lug in the brake caliper.
Tighten the rear axle nut to be specified
torque:
Rear axle nut torque:
88 N·m (8.9 kgf·m , 65 lbf·ft)
Adjust the rear brake pedal free play using
brake rod adjusting nut.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.

BRAKE PAD WEAR (only front brake)

Refer to the Safety Precautions on page 6.
Brake pad wear depends upon the severity
of usage, the type of riding, and road
conditions. (Generally, the pads will wear
faster on wet and dirty roads.)
Inspect the pads
maintenance interval (page 49).
Check the wear indicator grooves (1) in
each pad.
If either pad is worn to the bottom of the
grooves, replace both pads as a set. Visit
your Honda dealer for this service.
(1) Wear indicator grooves
at each regular
(1)
(1)
71