9 x 2 multi-format 4k presentation matrix switch (52 pages)
Summary of Contents for Tripp Lite B119-4X2-4K
Page 1
Models: B119-4X2-4K, B119-4X4-4K Este manual está disponible en español en la página de Tripp Lite: tripplite.com Ce manuel est disponible en français sur le site Web de Tripp Lite : tripplite.com Русскоязычная версия настоящего руководства представлена на веб-сайте компании Tripp Lite по адресу: tripplite.com Dieses Handbuch ist in deutscher Sprache auf der Tripp Lite-Website verfügbar:...
Note: The model (B126-1A1 HDMI over Cat5 Receiver Unit) shown in the below images is for illustrative purposes only. Your product may vary by model number, size or port orientation. The mounting options for B119-4X2-4K and B119-4X4-4K are the same.
Standard Installation Note: The diagram below shows a B119-4X4-4K installation. The installation will be the same for the B119-4X2-4K, except for the number of ports. RS-232 Cable Super Terminal Control 4K/60 Hz Source Up to 15 ft. (4.5 m) RS-232 28 AWG HDMI 2.0...
Page 5
Output port to switch the source being displayed. Note: The same four-button remote control is included with both the B119-4x2-4K and B119-4X4-4K. See the RS-232 Serial Control section in this manual for details on controlling the switch using Terminal Emulation Software.
RS-232 Serial Control Before using RS-232 Serial Control, you must first go to the Terminal Emulation Software and update the COM port settings. Go to the Setup drop-down menu and select the Serial port option. Select the COM port that is being used, and update the remaining settings as follows: Baud Rate (57600 or 9600), Data (8 bit), Parity (none), Stop (1 bit), Flow Control (none).
Page 7
RS-232 Serial Control Next, you will need to configure your software to allow input control. Go to the Setup drop-down menu and select the Terminal option. Update the following settings: Receive (LF), Local Echo (enable). The remaining settings can stay as they are.
Page 8
RS-232 Serial Control Once these settings are updated, the Terminal Emulation Software will recognize the switch, allowing you to enter commands to control it. The following table lists the available commands: Command Action Sw[x] [n] Switches the source being displayed on the selected output.
It is recommended you use Tripp Lite’s P569-CERT Series 4K HDMI cables with Ethernet, as they have been tested to work with the B119-4K Series Matrix Switch products.
TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of three (3) years from the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products.
Page 12
• Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications to this equipment not expressly approved by Tripp Lite could void the user’s authority to operate this equipment. WEEE Compliance Information for Tripp Lite Customers and Recyclers...