Install The Hba350I Mm - Dell HBA 355 Series User Manual

Install the HBA350i MM

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Angle the storage controller card and align the end of the card with the controller card connector on the system.
2. Lower the connector side of the storage controller card into the storage controller card connector on the system board.
NOTE: Ensure that the slots on the system board align with the screw holes on the storage controller card connector.
Figure 26. Install Dell HBA350i MM
3. Route the storage controller card cable along the wall of the system.
4. Align the screws on the storage controller card cable with the screw holes on the connector.
5. Using Phillips #2 screwdriver, tighten the screws to secure the storage controller card cable to the card connector on the
system board.
Installation and removal of cards 37