Honda CLARITY Plug-In Hybrid 2020 Owner's Manual page 547

■
What to Do After the Power System Starts
Once your vehicle's power system has started, remove the jumper cables in the
following order:
1. Disconnect the jumper cable from your vehicle's ground.
2. Disconnect the other end of the jumper cable from the booster battery -
terminal.
3. Disconnect the jumper cable from your vehicle's 12-volt battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery +
terminal.
Have your vehicle inspected by a nearby service station or an authorized Honda
Clarity Plug-In Hybrid dealer.
1What to Do After the Power System Starts
The indicators for the Vehicle Stability Assist
system, VSA® OFF, Collision Mitigation Braking
System TM (CMBS TM ), and low tire pressure/Tire
Pressure Monitoring System (TPMS) may come on
along with a message in the driver information
interface when you turn the power system on after
reconnecting the battery.
Drive a short distance at 12 mph (20 km/h). The
indicator should go off. If it does not, have your
vehicle checked by an authorized Honda Clarity Plug-
In Hybrid dealer.
uuJump Startingu
TM (VSA®)
545