Using The Remote Control - Sharp AH-XP10YH Series Operation Manual

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries. (AAA(R03))
Make sure the (+) and (-) polarities
are correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1
year in normal use.
• Replace the batteries when the re-
mote control displays "
• When replacing the batteries, always
change both and use the same type.
• If you will not be using the unit for a
long time, remove the batteries from
the remote control.
RESET BUTTON
• Press the RESET button to restore
the factory default settings of remote
control.
• Use a thin stick or a pin to press the
RESET button, in case the remote
control does not respond due to mis-
operation.
OM B088 EN+TH+VN+CS.indb 5
Battery cover
RESET button
".
EN-5
HOW TO USE THE REMOTE CONTROL
Point the remote control towards
the receiver window and press the
desired button. The unit generates
a beep when it receives the signal.
• Make sure nothing, such as curtains,
block the signal receiver window.
• The signal effective distance is 7 m.
7 m
CAUTION:
• Do not expose the receiver window
to direct sunlight. This may adversely
affect its operation.
• Use of certain fluorescent lamp in
the same room may interfere with
transmission of the signal.
• Do not leave the remote control
in direct sunlight or near a heater.
Protect the remote control from
moisture and shock.
Receiver
window
2022/6/21 13:16:17