Table of Contents
Advertisement
DESCALING
To maintain its performance, your HotCup™ water dispenser will require descaling once
every three months or so. You may need to descale your HotCup
frequently if you live in a hard water area.
By changing the MAXTRA+
cartridge more frequently, you will need to descale less
®
often. BRITA
recommends to exchange the MAXTRA+
®
1.
Completely remove the lid and remove the filter funnel and filter. Fill your HotCup™
water dispenser to the MAX marking on the water chamber and place an empty cup
on the drip tray. Replace the lid. Select a suitable setting for the dispensing control
and press the start button. Wait for the water to be dispensed into the cup.
2.
Add a citric acid-based proprietary descaling product to the hot water in the cup and
stir.
3.
Tip the contents of the cup into your HotCup™ water dispenser and close the lid.
4.
Place the empty cup on the drip tray and press the start button.
5.
Wait for the water to be dispensed into the cup.
6.
Discard the water from the cup.
7.
Repeat steps 4, 5 and 6 until your HotCup™ water dispenser is empty. Fill your
HotCup™ water dispenser with fresh water to the MAX fill level and place an empty
cup on the drip tray.
8.
Press the start button and wait for the water to be dispensed into the cup.
9.
Discard the water in the cup.
10.
Repeat steps 8 and 9 until your HotCup™ water dispenser is empty. This will rinse
any remaining descaling solution from your HotCup
11. When your HotCup™ water dispenser is completely cleaned, reinsert the filter funnel
and filter. Your HotCup
water dispenser is ready for use again.
™
10
VKT241_23EM1 (UK).indd 10-11
VKT241_23EM1 (UK).indd 10-11
water dispenser more
™
cartridge every 4 weeks.
®
water dispenser.
™
TROUBLESHOOTING
Problem
Possible Cause
The Instant HotCup™ will not
Your HotCup™ water
operate after the last dispense.
dispenser has not reset itself
after the boiling cycle.
Your HotCup™ water
Your HotCup
dispenser does not dispense
dispenser is not plugged in.
boiling water.
•
Your water tank is not place
in position.
•
Dispense has boiled dry
(E1).
Your HotCup™ water
•
Your HotCup™ water
dispenser does not dispense a
dispenser has excessive
full cup of water.
scale.
•
The dispensing control may
be set too low.
Solution
Your HotCup™ water
dispenser is still too hot after
the last boil cycle. Wait a few
seconds for it to cool slightly
before trying again.
water
•
Check your HotCup™ water
™
dispenser is plugged in and
switched on at the supply
socket.
•
Check that the dispensing
nozzle is positioned
centrally over the drip tray.
•
Check the fuse in the plug.
•
Allow your HotCup™ water
dispenser to cool down
completely then refill it with
water.
•
Descale your HotCup™
water dispenser.
•
Adjust the dispensing
control.
11
2023/3/8 09:39
2023/3/8 09:39
Advertisement
Table of Contents
