Product Specifications; Troubleshooting - Honeywell POWER PRESENTER PLUS 64/128 Instruction Manual

Hide thumbs

Table of Contents

Transmitter:

• Range: Up to 100 feet, depending upon

operating environment

• Dimensions: 2.6" (66mm)L x 1.5"(38mm)W x

0.5"(13mm)H

• Weight: 1 oz (24 g) with batteries

• Radio Frequency: 433.92 MHz

• Laser: Diode Laser, 5mW max output at

650NM, Class IIIa

• Power: One 3.0 V CR2032 lithium battery

• Battery life: 1 year under normal operation

Laser Pointer Information

Due to the potential of radiation exposure from the laser, the Food and Drug

Administration (FDA) requires that any user of this product report and return a

defective unit to the manufacturer. DO NOT point the laser light directly into the

eye area or attempt to open or disassemble this product for any reason.

Tampering with the laser product may be hazardous and will automatically VOID

the manufacturers warranty.

This product fully complies with FDA 21 CFR 1040.10 and 1040.11.

Troubleshooting

"I'm pressing the advance button but the slides are not advancing."

1) Check the cable connections.

2) Verify that the LED on the remote comes on solid when the advance or reverse button is pushed

and that the laser pointer is at full brightness when the laser button is pushed. If not, replace the

battery.

3) Verify that the transmitter has been trained to the receiver. Follow the instructions under

"Training the Remote to the Receiver".

4) Verify that the correct operating system driver is loaded on your computer. Try reloading the

driver, or try unplugging the receiver, waiting 10 seconds, and then plugging it back in.

"The LED on the remote flashes or does not turn on when I push the advance or reverse button, or

the l

the laser pointer is dim or does not work when the laser button is pushed."

aser pointer is dim or does not work when the laser button is pushed."

the l

aser pointer is dim or does not work when the laser button is pushed."

1) The battery is dead. Replace the battery.

"The internal Flash Drive does not mount on my computer."

1) Verify USB compatibility on your computer.

2) Download and install the needed Flash Driver (see section Using the USB Flash Drive).

"I'm getting a USB 2.0 hub error."

1) The USB device you are plugging into the Power Presenter hub port is a USB 2.0 device. Since

the Power Presenter is a USB 1.1 device, your USB 2.0 product will only work at the slower 1.1

speed. This should not cause any problems for your USB 2.0 device, but please check your

users manual for that device to confirm.