Table of Contents
Advertisement
5) The USB memory drive should be recognized in the same process as above. If a driver is
needed, please visit our website
required drivers.
Using the USB Flash Drive
1) The USB Flash drive will be displayed on your desktop as a drive under Windows and the Mac
OS. If the Flash Device is not automatically displayed you may need to load a USB Flash driver.
This driver is available at our website www.powerremote/resources_drivers.htm.
2) Use the drive just as you would an internal or external drive. For presentations you may run
them from your Flash drive or from the computer's hard disk drive. In some cases, the
presentation might run faster if the file is saved to the computer's internal hard disk drive for the
presentation.
Connecting Another USB Device
The USB Type-A, female port (rectangular shaped USB female connector) on your POWER
PRESENTER PLUS 64 or 128 receiver is connected to an internal USB hub port. This port will allow
you to connect other USB devices to your computer through your POWER PRESENTER PLUS 64 or
128 receiver unit. To use this port, simply connect a USB device with a Type-A connector into the
port.
Note:
Note: USB 2.0 devices will work at USB 1.1 speeds when connected to this port as the POWER PRESENTER
Note:
Note:
PLUS is a USB 1.1 compatible device.
Training the Remote to the Receiver
The remote has been trained into the receiver at the factory. The receiver can support up to 7 total
remotes.
To train a new remote, or re
To train a new remote, or re
To train a new remote, or re
To train a new remote, or re- - - - train an existing remote, into the receiv
train an existing remote, into the receiver: er: er: er:
train an existing remote, into the receiv
train an existing remote, into the receiv
1) Press and release the program button on the receiver. The LED lights solid.
2) Press the advance button (the largest button) on the remote three times. On the third press, the
LED will turn off, indicating the remote has been successfully trained.
To delete all of the remotes from the receiver:
To dele
te all of the remotes from the receiver:
To dele
To dele
te all of the remotes from the receiver:
te all of the remotes from the receiver:
1) Press and hold the program button on the receiver. The LED will light for 3 seconds then go out.
2) Release the program button.
Using the Remote
After connecting the receiver properly, simply start
your presentation or slide show software, put it in
slide show mode, and press the remote's larger
advance button to advance the slides and the smaller
reverse button to go back to the previous slide. Press
the smallest button to activate the laser pointer.
www.powerremote/resources_drivers.htm
AVOID EXPOSURE - LASER RADIATION
LASER
ACTIVATION
BUTTON
to download the
EMITTED FROM THIS APERATURE
ADVANCE
BUTTON
REVERSE
BUTTON
Advertisement
Table of Contents
