Linking Redlink™ Accessories - Honeywell Prestige 2.0 THX9421 Manual

®
THX9321 PRESTIGE 2.0 AND THX9421 PRESTIGE
2. Follow the prompts on the thermostat screen until
you reach the Wireless Setup screen. See Fig. 30.
3. While the Connected light is flashing green on the
EIM, press Next on the thermostat. After a short
delay, the screen will display Device Connected.
4. Press Next, as directed on screen, to link RedLINK
accessories.
Linking RedLINK™ Accessories
Fig. 32. Connect RedLINK accessories.
68-0311—07
®
Next
Fig. 30.
Next
Fig. 31.
IAQ WITH EIM
1. When you see the prompt Do you have RedLINK
accessories to connect? touch Yes or No.
a. If you select No, continue to step 5.
b. If you select Yes, you will be prompted to Press
Connect on New Accessories. Continue to step 2.
NOTE: Accessories must be at least 2 feet away from the
thermostat or EIM during the linking process.
2. While the Add Device screen is displayed (listening
mode), press and quickly release the CONNECT but-
ton on each new RedLINK accessory.
NOTE: For locations of CONNECT buttons on
RedLINK accessories, see "Locating the
Connect Buttons on RedLINK Accessories"
beginning on page 18.
Fig. 33. Thermostat in listening mode.
3. After a short delay (up to 20 seconds), check the
thermostat to confirm the connection of each
RedLINK accessory.
Fig. 34. Thermostat in listening mode.
4. Touch Done at the thermostat after all new RedLINK
accessories are connected.
NOTE: The thermostat displays a countdown timer
while in the listening mode. If it detects no
activity for 15 minutes, it exits the listening
mode.
16
Done