Power On; Power Failure - D-Link DGS-1016TL Manual

D-Link DGS-1016TL/DGS-1024TL Gigabit Ethernet Switch
Mounting the Switch in a Standard 19" Rack
Figure 2-3. Installing the Switch in a rack

Power On

Plug one end of the AC power cord into the power connector of the Switch and the other end into the local power
source outlet.
After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators
represents a reset of the system.

Power Failure

As a precaution, in the event of a power failure, unplug the Switch. When power is resumed, plug the Switch
back in.
7