Rear Panel Description - D-Link DGS-1016TL Manual

This indicator will light green immediately after the Switch is powered on to indicate
Power
the ready state of the device.
This indicator lights green when the port is connected to a Gigabit Ethernet, Fast
Ethernet, or Ethernet station. If the indicator is blinking green, data is either being
Link/Act
transmitted or received.
This LED indicator lights green when the port is connected to a 1000Mbps Gigabit
1000Mbps
Ethernet station.
This LED indicator lights green when the port is connected to a 100Mbps Fast
100Mbps
Ethernet station.

Rear Panel Description

The rear panel of the Switch consists of an AC power connector. The following shows the rear panel of the
Switch.
The AC power connector is a standard three-pronged connector that supports the power cord. Plug-in the female
connector of the provided power cord into this socket, and the male side of the cord into a power outlet. The
Switch automatically adjusts its power setting to any supply voltage in the range from 100 ~ 240 VAC at 50 ~ 60
Hz.
D-Link DGS-1016TL/DGS-1024TL Gigabit Ethernet Switch
Figure 1-3. LED Indicators
NOTE: If the Link/Act LED indicator lights green and both of 1000Mbps and
100Mbps LED indicators are off, this means the port is connecting to a 10Mbps
Ethernet station.
Figure 1-4. Rear panel view of the Switch
3