Table of Contents
Advertisement
Unit ID
This three-digit number keeps data separated by instrument when more than one instrument is
used in a network. If multiple sensing units are attempting to communicate with the same Host,
then the units must all have a different Unit ID.
1. Press [Y/+] to step through all 10 numerals (0 to 9). If you pass the numeral you want, keep
pressing [Y/+]. After it counts up to 9, it starts counting up from 0 again.
2. Press [N/-] to advance to the next digit. The next digit to the right flashes.
3. Repeat this process until all three digits of the Unit ID are entered.
4. Press [MODE] when you are done.
Press [Y/+] to save the change.
l
Press [N/-] to discard the change and move to the next sub-menu
l
NOTE: Unit ID is mainly for the 3G Handheld PIDs with the 2.0 Bluetooth Wireless Modems. For
instruments with Mesh Modem options, the Unit ID is set in the RAELINK3-Mesh.
LCD contrast
The display's contrast can be increased or decreased from its default setting. You may not need
to ever change the default setting, but sometimes you can optimize the display to suit extreme
temperature and ambient brightness/darkness conditions.
The minimum value is 20.
l
The maximum value is 60.
l
1. Press [Y/+] to increase the value or [N/-] to decrease the value.
2. Press [MODE] to save your selection.
Press [Y/+] to save your new contrast value.
l
Press [N/-] to undo it and return to the previous value.
l
Handheld PID Monitors
90
User Manual
Advertisement
Table of Contents
