Table of Contents
Advertisement
TeamPoS 3000XT
6.1.3 Powering ON
1.
Make sure all peripherals are securely connected to the control unit.
2.
Make sure the power cord is plugged into the power source.
3.
Press the power switch on the side of the unit.
4.
Confirm the power/battery status LED is ON and not blinking, indicating the
successful completion of power-up diagnostics.
Any hardware errors detected on power up will appear on the display. Note that the
Model VF60 two-line alphanumeric display does not display error messages.
6.1.4 Powering OFF
Note: Some peripherals, such as scanners and scales, may be separately
powered. Check the peripheral manuals for instructions for these
peripherals.
1.
Press the power switch to turn OFF the terminal.
Note: Depending on BIOS setup, a momentary depression of the switch may
signal the application to shut the unit down, which could take a few
minutes. If power is not immediately turned off, either wait for the
application to shut the unit down, or keep the switch depressed for
approximately 4 seconds. For proper shutdown procedures, see the
application software documentation.
D900000172
Installation and Maintenance Manual
6-3
Advertisement
Table of Contents
