Table of Contents
Advertisement
1. Lock button
2. Switch trigger
ASSEMBLY
2
1. Wrench
2. Hex wrench
2
1
4
3
1. Hex bolt
2. Saw blade
3. Outer flange
4. Inner flange
Switch action
005498
1
CAUTION:
2
•
Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
For tool with lock button
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
For tool without lock button
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Removing or installing saw blade
001424
1
CAUTION:
•
Be sure the blade is installed with teeth pointing up at the front of the
tool.
•
Use only the Makita wrench to install or remove the blade.
To remove the blade, hold the outer flange with the wrench so that it cannot
revolve, then use the hex wrench to loosen the hex bolt counterclockwise.
Then remove the hex bolt, outer flange and blade.
To install the blade, follow the removal procedure in reverse. BE SURE TO
005500
TIGHTEN THE HEX BOLT CLOCKWISE SECURELY.
When changing blade, make sure to also clean upper and lower blade guards
of accumulated sawdust. Such efforts do not, however, replace the need to
check lower guard operation before each use.
CAUTION:
•
The inner flange has a 25 mm diameter on one side and a 25.4 mm
diameter on the other. The side with 25.4 mm diameter is marked by
"25.4". Use the correct side for the hole diameter of the blade you intend
to use. Mounting the blade on the wrong side can result in dangerous
vibration.
7
Advertisement
Table of Contents
