Table of Contents
Advertisement
1. Chain
2. Spacer
3. Bolt (3/8 x 2-1/2 inches)
4. Washer (3/8 x 7/8 inch)
Note: For proper operation of the rake, the chains
must be slack when the rake is in the lowered
(operating) position.
Note: Make sure all the finishing rakes are
overlapping properly, laying flat and none of the
chains are tangled or twisted.
3
Adjusting the Link Assembly
No Parts Required
Procedure
1. With the rake mounted and secured on the traction
unit, raise the attachment.
2. Measure the gap between the top washer and the
spacer in the link assembly on the attachment
adapter as shown in Figure 7.
Note: The gap between the washer and the
shoulder should be 0.060 to 0.080 inch (.15 to .20
cm) (Figure 7).
Figure 6
5. Locknut (3/8 inch)
6. Traction unit rear frame
7. Long arm of the lift arm
assembly
1. 0.060 to 0.080 inch (.15 to
.20 cm)
2. Jam nut
3. If the gap is not correct, loosen the jam nut and
tighten or loosen the adjustment nut on the link
assembly as needed to change the gap (Figure 7).
4
Reading/Storing the
Documentation
Parts needed for this procedure:
1
Operator's Manual
1
Parts Catalog
Procedure
1. Read the documentation.
2. Store the documentation in a safe place.
6
Figure 7
3. Adjustment nut
Advertisement
Table of Contents
