Mounting The Tooth Rake To The Traction Unit - Toro 08751 Operator's Manual

2. Align the lift arm with the bracket on the attachment
adapter (Figure 4) and connect them using the pivot
bar as illustrated in Figure 5.
Note: When moving the attachment adapter, use
the handle provided on the back of the adapter
(Figure 4).
1. Lift arm
1. Attachment adapter
2. Pivot bar
3. Cotter pins
3. Secure the pivot bar with 2 cotter pins and a bolt
(3/8 x 1-1/4 inches) (Figure 5).
Figure 4
2. Attachment adapter
Figure 5
4. Bolt (3/8 x 1-1/4 inches)
5. Locknut (3/8 inch)
6. Handle
2
Mounting the Tooth Rake to
the Traction Unit
Parts needed for this procedure:
2 Bolt (3/8 x 2-1/2 inches)
4 Washer (3/8 x 7/8 inch)
2 Spacer
2 Locknut (3/8 inch)
Procedure
1. Remove any attachment from the rear of the
machine.
2. Lower the traction unit adapter and back the traction
unit into position in front of the attachment adapter.
Note: Make sure the locking lever is pivoted to the
left (unlocked position) as viewed from the rear of
the machine.
3. Slide the attachment adapter onto the traction
adapter.
Important: The long arm of the lift arm
assembly must be under the traction unit rear
frame assembly (Figure 6).
CAUTION
If you are not careful, you could pinch your
fingers between the attachment and traction
unit adapters.
Always lift and move the attachment using the
handle on the back of the attachment adapter
(Figure 6).
4. Pivot the locking lever to the right to lock the
adapters together.
5. Secure the top link of each chain to the inside of the
lift arm using a bolt (3/8 x 2-1/2 inches), 2 washers
(3/8 x 7/8 inch), a spacer, and a locknut (3/8 inch)
(Figure 6).
5