Honeywell FIRE-LITE ALARMS ES-200X Supplement Manual page 7

1.8.4 FCC Compliance
Contains FCC ID:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference. (2) This device must accept any interference received, including, an interference that may cause undesired operation.
• Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.
• This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines and RSS‐102 of the ISED radio frequency (RF) Exposure rules. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter. The antenna should be installed and operated with minimum
distance of 8" (20 cm) between the radiator and your body.
2.6 UL Power-limited Wiring Requirements
Power-limited and non-power-limited circuit wiring must remain separated in the cabinet. All power-limited circuit wiring must remain at
least 0.25" (6.35 mm) away from any non-power-limited circuit wiring and non-power-limited circuit wiring must enter and exit the cabinet
through different knockouts and/or conduits. When connecting the ground cables, be sure that the AC mains ground is the first one installed,
closest to the backbox. The antenna must be mounted 8 in (20cm) from the display/keypad. A typical wiring diagram for the ES-200XP is
shown below.
Maintain minimum 0.25" between
power-limited and non-power-
limited circuits wiring.
Power-
limited
Circuits
(Class 2)
AC
Power
Grounding
Stud (see
Figure 2.4)
Supplement for ES-200XP Applications — P/N LS10387-000FL-E:A 2/23/2023
RI7ME310G1WW
Non-power-limited Circuits
4XTMF
Ground
Cables (2)
#71073
Figure 2.10 Typical UL Power-limited Wiring Requirements
Power-limited Circuits (Class 2)
display/keypad
location
To
Batteries
Wire Nut
Antenna must be mounted
8 in (20cm) from the
display/keypad.
Power-
limited
Circuits
(Class 2)
CLSS
Pathway Pro
7