Cisco NCS 4206 Installing page 40

Connecting to the Auxiliary Port
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
Note
Step 5
When the InstallShield Wizard Completed window appears click Finish.
Connecting to the Auxiliary Port
When a modem is connected to the auxiliary port, a remote user can dial in to the chassis and configure it.
Use a light blue console cable and the DB-9-to-DB-25 connector adapter.
Note
To connect a modem to the chassis, follow these steps:
Step 1 Connect the RJ45 end of the adapter cable to the black AUX port on the chassis, as shown in the figure below.
Installing the Cisco NCS 4206
40
The console cable and DB-9-to-DB-25 connector are not included with the Cisco NCS 4206; they are ordered
separately.
Installing the Cisco NCS 4206