Reversing Door Swing - Sharp SJM60MK Operation Manual

5. Reversing Door Swing

This refrigerator gives you the option of either opening the door from the left or right
side. The unit is delivered with the door handle on the left side. Should you desire to
change the direction of the door swing, please read the following instructions:
Note:
Do not discard or throw away any component during dismantling of door. You need to
reuse these components when reassembling the door.
Changing the Door Swing
1.Remove the upper hinge cap (7).
2.Remove the two bolts (6) that fasten the upper hinge (5) to the right side of the cabinet top.
3. Lift the door carefully and place it on a padded surface to prevent scratches.
4. Remove the plug (9) and transfer it to the uncovered door hinge opening on the right side
of the unit. Be sure to press the plug firmly into the opening.
5. Remove the two screws (1) that fasten the lower hinge (2) to the right side of the unit.
6. Remove the screw-type levelling foot (4) (Adjustable High Foot) and transfer it to the right
as shown in the figure below.
7. Set the door into its new place making sure the pin enters the bushing at the lower frame
section (hole).
8. Secure the upper hinge (5), previously removed in step 3, on the left side of the unit. Make
sure the pin enters the bushing on the upper frame section (hole).
9. Loosely secure the lower left hinge (2) and do not tighten the bolts until the door is in the
closed position and levelled.
10. Insert the plug (9) on the uncovered holes (right side).
11. Replace the upper hinge cap (7).
Parts:
(1) Screw
(2) Lower Hinge
(3) Adjustable Low Foot
(4) Adjustable High Foot
(5) Upper Hinge
(6) Screw Bolt
(7) Upper Hinge Cap
(8) Shaft Sleeve
(9) Plug