Table of Contents
Advertisement
To open the gate motor, hold the badge in front of the RFID scan area for 3 seconds. Two
short beeps indicate that the gate is opening.
6) Replacing a badge
RFID badges do not have predefined functions. It is the programming step that sets the
badge's function. Badge colours simply enable users to recognize their functions. If a badge
is lost, it can be replaced by any other badge by repeating the programming step.
3. Installing the main or additional monitor
1
4
7
1 - Position the wall bracket so that the screen of the monitor is approximately 1.60 m above
the floor.
2 – Mark the location of the holes using the U bolt.
3 – Drill.
4 – Use pegs adapted to the bracket (those supplied are suitable for solid walls).
5 - Attach the wall bracket.
6 – Connect the two intercom panel wires and the two power supply wires following the
wiring diagram.
7 - Position the monitor on the wall bracket.
8 - Depending on the configuration selected, and when wiring is completed, the interface
may have to be configured.
GB7
1m60
2
5
WelcomeEye Connect Pro / V5
3
DES 9900 VDP
Wi 2.4GHz
5
3
1
0
2
2
24V
550mA
+
-
1/3
2/4
SMARTHOME FRANCE
19 avenue Marcel Dassault 37200 TOURS
FRANCE
5
3
1
0
2
2
6
Advertisement
Table of Contents
