NEC UNIVERGE SV9300 Migration Manual page 10

SV8300 System Data that are not Subject to Conversion
CM40 Y=08
CME6 Y=50
CMF6 Y=2
NOTE: When migrating the system data for the System Speed Dialing (300 memories), see `To
Migrate the System Data for the System Speed Dialing (300 Memories)'.
(7) Differences between SV8300 and SV9300 system data including initial value changes in some
commands. Such differences are automatically converted by using System Data Conversion Tool.
The converted system data can be confirmed in a report issued from the System Data Conversion
Tool.
(8) The following service settings that have been assigned by users are converted by the System Data
Conversion Tool.
- Station Speed Dialing
- One Touch Key Calling
- Call Forwarding-All Calls
- Call Forwarding-Busy Line
- Call Forwarding-No Answer
- Call Forwarding-Logout
- Elapsed time before Call Forwarding-No Answer for internal call
(9) The following service settings that have been assigned by users are not converted by the System
Data Conversion Tool. Set the data again after conversion to SV9300.
- Timed Reminder (Automatic Wake Up)
- Do Not Disturb
- Message Waiting
- Timed Queue
- Call Answer Preset
- Switching of Multiline Terminal Ringing Tones
- Setting Status for OAI SSFR (Service Set Facility Request)
- Multiline Terminal Display Enhancement for Universal Design
- Dual Ringing
- Message Reminder
- Call Restriction/Room Cutoff
- Busy Out from ACD/UCD group
- Voice Mail Live Record
- Split Call Forwarding-All Calls/Busy Line/No Answer
- Access Code Number Setting in Mobility Access Mode
- Reverse Contrast on the LCD
- Protection Mode for DT700 Series
- Mobility Access Mode
- Mobile Phone Number Link up with a Mobility Access Station Number/Destination of ISDN
Alternative Routing (station basis)
(10) The following data cannot be migrated.
- Outgoing/Incoming Call History
- Billing data
RS-232C Data speed
Mobile phone number link up with a Mobility Acces
s station number
MP-FP command output setting (for realtime mode)
- 4 -
CHAPTER 1 OUTLINE
SV9300 System Data
for Manual Setting
CM40 Y=08
CME6 Y=50
CMF6 Y=2
Page 19