Advertisement
Quick Links
Advertisement
Related Manuals for Harol TC110
Summary of Contents for Harol TC110
- Page 1 Assembly instructions Awnings TC110 - TC120 - TC130 art.nr. 34581...
-
Page 2: General Warnings
! Our products must be installed so that all parts remain accessible at all times for maintenance and eventual repairs. If this is not the case, Harol cannot be held responsible for any additional costs (f.e. demolition activities, repairs to facades and interior walls) as a result of this. -
Page 3: Assembly Manual
If the walls are made of cellular concrete or hollow brick, the correct type of screw must be used, e.g. coach bolts, etc. For this, take comprehensive advice from your sup- plier of attachment materials. The company Harol accepts no responsibility for any attachment screws that come loose. - Page 4 Assembly instructions awnings TC110 - TC120 - TC130 Slide screws C into the slot in the bottom of the assembly bracket and secure the awning with the locking nuts. Repeat this operation with set screw D or hexagon bolt D. Tighten the attachment screws firmly before operating the awning.
- Page 5 Assembly instructions awnings TC110 - TC120 - TC130 Once the angle is correct, both tilting mechanisms Mounting type Angle (in °) must be securely tightened. To do this, tighten 0 - 38 both pointed screws ‘A’. Now, replace the covers 38 - 76 on the side consoles.
- Page 6 Assembly instructions awnings TC110 - TC120 - TC130 E. Connection of the single-pole switch and setting of the motor E1-Single-pole switch Firstly, connect the electric cable of the motor to a test cable. Four wires exit the motor: yellow-green (earth), blue (neutral), brown and black (up- and down direc- tion).
- Page 7 Assembly instructions awnings TC110 - TC120 - TC130 E2-Setting of the end switches of the motor In principle the motor is already set at the factory, but it may be necessary to change the setting. For this proceed as follows: For a LT-motor (TC110 –...
- Page 8 Assembly instructions awnings TC110 - TC120 - TC130 Then press the blue setting button. Let the motor run down for 20 cm. Close the awning completely. One can hear the motor hum for a few seconds, then it switches itself off.
- Page 9 Assembly instructions awnings TC110 - TC120 - TC130 E3. Why use a MRI 2? When the same switch operates different motors a relay box must always be used. If relay boxes are not used, the built-in limit switches of the motor will very quickly burn due to the high inductive and capacitive voltages that can be generated between them.
-
Page 10: Fault Finding
Assembly instructions awnings TC110 - TC120 - TC130 F. Fault-finding Your Harol awnings are 100% checked before they leave the factory. It is therefore highly unlikely that faults could be present whereby e.g. the motor does not work after assembly. Before contacting our services it is advisable to first thoroughly check a number of points. - Page 11 Assembly instructions awnings TC110 - TC120 - TC130 Faulty: there is no symmetry, distance A does not correspond with distance B Faulty: the articulated points are not in one line Correct: the articulated points are in one line and distance A equals distance B...
- Page 12 G. Mounting the side flaps Please, remove the lateral fabric before closing the awning. Harol reserves the right to make changes at any time to the construction without having to inform the client beforehand, and therefore without having to adapt existing installations.