Page 1
I-7000/M-7000 Quick Start v1.3, Fed. 2020 ■ Packing List Quick Start In addition to this , the package includes the following items: CA-5810/CA-3813 I-7000/M-7000 Plastic Rail DB-1820 (10 or 13-pin) (For I-7000/M-7000) DN-1822 CA-252518D-1 DN-1823 CA-2525015D DN-8P8C CA-090910-A CA-5810 is for I-7017R-A5-G and M-7017R-A5-G...
Page 2
GND pin and then power on the module to INIT access the configuration mode. Connect to the PC and the Power Supply Note: You should only connect a single I-7000/M-7000 module to the RS-485 bus during the configuration process. 1) Using an RS-232 to RS-485 Converter I-7520/tM-7520U...
Page 3
Install the DCON Utility Pro The DCON Utility Pro can be obtained via FTP from the address below or by scanning the QR code: http://ftp.icpdas.com/pub/cd/8000cd/napdos/driver/dcon_utility/ Set the Communication Parameters...
Page 4
Search for and Configure the Module The initial values will be displayed in Init mode. You can change the settings. Reboot the Module in “Normal” Mode Set the switch to the “ Normal ” position (or disconnect the INIT* to the GND) then reboot the module to apply the new configuration.